This adjustable design can reduce the pressure on the cervical spine caused by sitting. Besides, this digital microscope with 3MP HD sensor has a 3-inch display that can be inclined at an angle of 45°. It has three output methods and a high object distance which permits users to do repairing or soldering work on the table. With two LED fill lights, the HDMI digital microscope can reduce reflection, shadow, and image errors so as to improve user experience. Not only it can reduce image mistakes and errors, but also it brings a great visual experience. I have already designed a board with 4 outputs, but I haven't built it.Equipped with the exclusive lens and HD sensor, the Andonstar ADSM201 HDMI Digital Microscope provides clear and high-resolution images with a deep depth of field, less delay, and less reflection. If you want to have a setup with multiple LED strips you need to design a board with multiple outputs. The singleLED board - as its name suggests - features only one LED output. I used slow-curing epoxy.ĭrill holes in the project box for the switch (6mm) and the potentiometer (6mm should be enough but was too tight so I used 8mm).ĭrill a 4mm hole for the wires to the led strips.Ĭonnect the Arduino and the battery packs and put them inside the project box.įasten the project box using double-sided tape.īig thanks to my wife for letting me use the action krisztian,

Note that there is a small grove at the back for the strip, this ensures that the strip is close to the profile to maximize cooling. Put the led strip back inside the aluminum profile. Remove the old wires (they are too short to reach the box) and solder new wires. I used a hacksaw to cut profile+cover at the same time to ensure the got the same length.Ĭut the led strips at one of the cut points using a side cutter. Remove the led strip from the aluminum profiles.Ĭut the aluminum profiles and the covers to appropriate length. This is a simple, low-cost and quick project that can get a high spouse acceptance factor.

Andonstar adsm201 microscope